Paletti Profilsysteme Logo Header
Contact: (267) 289-0020
E-mail: sales@palettiusa.com
Freigabe nach TISAX
Zertifiziert nach ISO 9001:2015

Linear Motion Systems 16

Track Profiles

The Paletti actuator system 16 is based on several types of track profiles and carriages. The carriages run on 16mm diameter steel rails that are pressed into the track profiles. Specific loading, speeds and acceleration are catered to by using a combination of drive units, Timing Belt widths and carriage lengths that meet the needs of most designers.

Führungsprofil F16 40x40 Führungsprofil F16 40x80/40 Führungsprofil F16 40x80/80 Führungsprofil F16 80x80
F16 40x40 F16 40x80/40 F16 40x80/80 F16 80x80
Führungsprofil F16 80x120 Führungsprofil F16 80x120 8N  
F16 80x120 F16 80x120 8N    
The ground steel rails are pressed into the profile slot on each side of the track profile and forms a rigid stable unit. Within highly dynamic systems they are doweled to the profile.


The carriages are made from one extruded profile and come in several standard sizes. Specific carriages lengths of up to 2300mm long are manufactured to meet the needs of each specific application. For high load systems the carriages are manufactured with additional rollers or as a combination of shaped and flat rollers. Should rollers need to be changed standard carriages are made with service pockets so the rollers can be serviced or replaced with the carriage in place. The rollers are adjusted via two excentric axles and fixed using a double locking mechanism of a large locknut retained in position by a grub screw. Lubrication of the rollers and guide rails is by a wiper and lubrication system with felt pads that retain the lubricant. For high dynamic loads we recommend the use of our external lubricant. For carriages with short strokes lubrication of the rollers may not be guaranteed and in such cases service pockets with internal felt pads to wipe and lubricate the system are required. The timing belt is attached to the carriage by internal or external timing belt tensioners.

Laufwagen 16/160/60/2/S Laufwagen 16/200/60/2/S Laufwagen 16/160/60/2 sl
16/160/60/2/S 16/200/60/2/S 16/160/60/2 sl

Pulley Assemblies

The pulley assemblies are manufactured for timing belts AT10/22 and AT10/50. The motor is attached using standard motor attachment flange plates or plates to suit customer requirements. The bore of the pulley assembly is either plain or comes with a shrunk steel insert to suit customer drive requirements. Motors can be either direct drive or via flexible coup­lings, timing belt gearing can also be provided.

Zahnriemenumlenkung 40/40 Zahnriemenumlenkung 40/40 kompakt Zahnriemenumlenkung 40/80
40/40 40/40 heavy duty 40/80
Zahnriemenumlenkung 80/80 Zahnriemenumlenkung 80/100 Zahnriemenumlenkung 80/120
80/80 80/100 80/120